please add your input about absolute positioning here ..
If i use the absolute positioning example and position to "vertical -10" then to "vertical
10" then back again "vertical -10" it doesn't point in the..
I had similar probs with v0.8.5, now even more apparent with v0.8.8/0.8.9.
Single movements of left/right/up/down seem ok, but when using absolute po..
The camera does not react on positioning if the delay between 2 steps is too small.
Originally I had the delay at 180ms, increased it to 200ms.
Mayb..
Adam, what system are you using?
Processor, Memory, USB 1.1 or 2.0
all there influence the required delay between 2 steps..
Thanks for the introduction of the configurable step delay - this has now ensured that:
Left-10 = Left-1, Left..
This is my setup:
P4, 3.0GHz,
1Gb RAM,
USB 2.0..
If I try to go to: pos--32,-1 (from home), it only seems to go down 1 and then left 16 ???
I just tested - this works on both of my setups - can anyb..
The positions read -32, -1
(and I realise that 32 would normally be out-of-bounds, but I have added 1 to the left/right in the config)..
NOTE - It's not just horizontal movement thats not working properly for me:
pos-0,-11 only moves the cam down 5
&nb..
I have just tested your configuration.
It worked fine for me both with IE and Firefox.
I have tested your interface as well as the direct commands y..
I have checked the box to make sure my camera is 'listed' - I assume this will become available on the site soon.
I am using both IE and Firefox too ..
you need to stop/start the web server for it to get listed as LogiSphere only connects 'back home' on web server start..
Adam, I did some testing on your camera. Now that there is some light, things were clearer
I don't know what your current delay setting is, but to m..
The step delay was 100 when you were testing it earlier. I left it at this, as it seemed to do the same whatever step delay I used (just goes slower!)..
the step limit to 10 is a limitation, not a bug. I wanted to avoid people entering /left-200 and blocking the cam for a long time.
..
Hi ! I upgraded to 0.9.0 and tried the absolute positioning out. I set the delay to 1000 so I could
watch the cam move, and counted the number of st..
I have the exact same issue with the absolute positioning not working correctly. I have a number of points of interest in my back yard and I have th..
Bug has been found and fixed. Upgrade to 0.9.1
Thanks to everybody for reporting the problem
If you have 0.9.0 installed, see the Member Page for a..
Hi ! After more testing of how the camera moves either with logisphere, or just using the
quick assistant window, I have come to the conclusion that ..
Yeah, I think I may be noticing a slight amount of this:
It seems if I select an absolute position right after I have reset to home (say: pos-13,-10)..
I've now had the same problem 3 times, more of a problem with the tilt not going "down" enough
after a while. Each time I have tried to home the cam,..
Hi ! After a little more research, I found that opening the cam up and removing the reflective plastic
hemisphere under the transparent plastic cover..
How can I turn the whole absolute positioning off? I don't really need it and it causes that the camera does not turn right or left as far it can. For..
you can't turn it off - but you can set different limits in your config.txt
Default values are:
Hmin = -31
Hmax = 31
Vmin = -11
Vmax = 11
increase 3..
From Pete:
Hi ! After more testing of how the camera moves either with logisphere, or just using the
quick assistant window, I have come to the concl..